Most efficient electric heating: what really cuts running costs

The most efficient electric heating, in the sense of the most heat for each unit of electricity, is a heat pump. Among ordinary electric heaters there is no winner on efficiency: panel heaters, oil-filled radiators, fan heaters and infrared panels all turn every kilowatt hour into a kilowatt hour of heat. What separates them is how much power they draw, how well they are controlled and when you run them.

In short

OptionHeat per kWh of electricityWhat decides the cost
Direct heaters (panel, oil-filled, fan, infrared, electric radiators)About 1 kWh: 100% efficientPower rating, hours of use, thermostat and timer
Storage heatersAbout 1 kWh, bought at cheaper off-peak ratesTariff, timing and controls
Electric boilerAbout 1 kWhTariff and controls
Heat pumpAround 3 kWh, according to the Energy Saving TrustDesign, installation and running temperatures

Advice checked against the Energy Saving Trust and Centre for Sustainable Energy guidance, as of 17 November 2026.

Why every direct electric heater is 100% efficient

The Centre for Sustainable Energy explains that electric room heaters are considered 100% efficient because all the electricity they use is converted into heat. A 2 kW panel heater and a 2 kW fan heater running flat out for an hour both use 2 kWh and give out 2 kWh of heat.

So when an advert claims one electric heater is “more efficient” than another, it usually means something else: better controls, a lower power rating, or heat delivered in a way that feels warmer sooner. None of that changes the physics.

What it does mean is that efficient is not the same as cheap. The Energy Saving Trust notes that electricity costs around four times as much as gas per unit, so direct electric heating is expensive to run, especially in a poorly insulated home.

How to compare running costs

Use the power rating:

kW × hours of use × price per kWh = cost

A 2 kW heater for 3 hours a day uses 6 kWh. Multiply by the unit rate on your bill. A heater with a thermostat will cycle on and off once the room is warm, so it uses less than this maximum.

Choosing the right heater for the job

Because efficiency is equal, the right choice depends on how you heat the room. The Centre for Sustainable Energy suggests:

  • Heating a whole room for hours: a convector or panel heater, or an oil-filled radiator, with a thermostat and timer. They warm the air evenly and can be controlled so the room does not overheat.
  • A quick burst of warmth: a radiant heater, such as halogen or infrared, which warms the people and objects in front of it. They work fast, but the warmth does not linger once they are off.

The Centre for Sustainable Energy adds a warning about infrared panels used as the only heat in a room: the air stays cold, so moisture can condense on cold surfaces and cause damp.

Storage heaters: cheaper electricity, not more efficient

Storage heaters charge overnight, when electricity is cheaper on tariffs such as Economy 7, and release heat during the next day. They are no more efficient than other heaters, but they buy most of their electricity at the lower rate, which the Energy Saving Trust describes as a middle-ground option between direct heating and a heat pump.

To get the most from them:

  • check that they charge only during your off-peak hours;
  • use the input and output controls, or a modern unit with automatic controls, so heat is not used up before evening;
  • avoid topping up with direct heaters at peak rates.

If you have an older meter that uses the Radio Teleswitch Service, the Energy Saving Trust advises contacting your supplier, as RTS is being phased out. Our guide to why your electricity bill is so high explains how to check day and night readings.

Heat pumps: the efficient electric option

A heat pump uses electricity to move heat from the outside air or the ground into your home, rather than turning electricity into heat directly. The Energy Saving Trust describes them as about three times more efficient than standard electric heaters, and often the most cost-effective electric option in the long run.

They cost more to install and need a suitable home, with radiators or underfloor heating sized for lower water temperatures, although some models suit homes without a wet system. Grants exist in parts of the UK, so check the current scheme for your nation before getting quotes. See how does a heat pump work.

What cuts electric heating bills most

Whatever heater you have, these make the biggest difference:

  1. Insulation and draught-proofing: the less heat you lose, the less any heater has to run. Start with loft insulation.
  2. Thermostats and timers on every heater, set to the temperature you need, not the highest setting.
  3. The right tariff: off-peak rates matter for storage heaters and electric boilers.
  4. Heating only the rooms you use, with doors closed.
  5. Right-sized heaters: an oversized heater without a thermostat wastes money; an undersized one runs flat out and never quite warms the room.

Get at least three quotes for a new fixed system, from an installer registered with a trade body, as the Energy Saving Trust recommends. More guides are in the Energy section.

Share your love
Avatar photo
Mathieu Kieffer
Articles: 49